HomeFT1A SmartAXIS Touch

Our newest 3.8" operator interface touchscreen with built-in PLC.

FT1A-Touch and HG1G Messages in this topic - RSS

scott g
scott g
Posts: 4

7/15/2019
Hello All,

I am trying to get a FT1A touch sutup for modbus TCP to display my project that is loaded in the FT1A on a HG1G display about 250 feet away on a Cat6 cable directly connected between the FT1A and the HG1G. Any suggestions, tips or tricks?

Thanks,
Scott
0 link
Shane
Shane
Moderator
Posts: 282

29 days ago
Have a look at the thread below where this scenario was discussed, only exception is RTU vs TCP but you have to do most of the same steps.

http://us.idec.com/forum/messages.aspx?TopicID=1209

Once you have the addresses setup at the FT1A with the data you want display on the HG1G it's fairly easy to grab the data with the HG1G via Modbus.
0 link
scott g
scott g
Posts: 4

23 days ago
Shane wrote:
Have a look at the thread below where this scenario was discussed, only exception is RTU vs TCP but you have to do most of the same steps.

http://us.idec.com/forum/messages.aspx?TopicID=1209

Once you have the addresses setup at the FT1A with the data you want display on the HG1G it's fairly easy to grab the data with the HG1G via Modbus.


I have done the script [0:HR 400001] = [ #D 0000 ]; in the Touch, as my base screen I am trying to show on the HG1G has all numdisplay and word buttons ( #D 0000) on it.

How do I "grab" the data with the HG1G?

Do I build a new base screen project in O/I NV4 for the HG1G or can I load the O/I NV3 project I have made for the touch already into the HG1G?

Thanks
0 link




Powered by Jitbit Forum 8.2.0.0 © 2006-2013 Jitbit Software